Mobile Integrated Solutions

I use MobiLinc HD and MobiLinc Pro on my Android devices. I use Linear GDOOZ-4 Z-Wave Garage Door Openers on my garage doors. The Android devices are working fine but the iOS devices with Mobilinc PRO will not operate the Linear GDOOZ-4 Z-Wave Garage Door Openers. Any suggestions?

The Linear garage door opener is showing up as a "status only" device in MobiLinc HD.

Thank you!!

Hi dbuss,

What does the ISY Admin Console report that device is?

Click on the device in the Admin Console.
On the right side in the main part of the Admin Console, look at the top where the name of the Garage Door Opener is.
Just under that the Admin Console lists the Z-Wave Node number followed by a type.

What is the type that's listed? Please respond with the exact phrase listed here.

Wes

Hi Wes,

Here's what it says: ZW010_1 - Barrier

Thank you!!

Thanks dbuss,

I'll get it looked at. Just to confirm is this just an open/close (on/off) type of control?

Wes

AdminWes wrote:Thanks dbuss,

I'll get it looked at. Just to confirm is this just an open/close (on/off) type of control?

Wes

Hi Wes,

Yes, it is just an open/close, on/off control. As I mentioned in my previous post, it works fine on my Android devices. I did have to change the labeling from on/off to open/close.

Thanks for looking into this.

Dick Buss