Page 1 of 1

MorningLinc

PostPosted: Mon May 23, 2011 7:47 pm
by ssingh1234
Hi there, I am trying to add a morninglinc RF module that can control my morning industry door lock. But, there is no option in devices for a morninglinc module. I have tried pretty much all the devices listed within Mobilinc HD with no luck.

pls advise - thank you!

Re: MorningLinc

PostPosted: Tue May 24, 2011 7:37 am
by AdminWes
Hi ssingh1234,

The MorningLinc is slightly different than most INSTEON devices. Most devices will accept commands from any controller that knows its INSTEON ID. In the case of the MorningLinc you need to manually link the MorningLinc to your SmartLinc first by going through the button press and hold technique to link the MorningLinc to the SmartLinc. Once linked, try adding the MorningLinc to MobiLinc as a SwitchLinc and attempt to command it ON and OFF.

I will attempt this here in our test lab as well, to confirm.

Wes

Re: MorningLinc

PostPosted: Tue May 24, 2011 8:11 pm
by ssingh1234
ok thanks - I got it going. I didn't have the morninglic working with the smart controller properly as you had stated.

It would be nice if in MobiLinc you would have a way to add graphics as well. It would help if there was a way to easily distinguish with all the switches.

Re: MorningLinc

PostPosted: Wed May 25, 2011 6:14 am
by AdminWes
Great! Glad to hear it's working for you.

Thanks for the feedback on adding graphics on switches. We have a few features planned in the area that hopefully will address this.

Wes