by AdminWes » Sat Feb 28, 2009 7:46 pm
Yes. iLinc reports the current status of the Insteon Device including On, Off, 0%-100% when you select the Insteon Module from the device list.
From this same page in iLinc you can also command the device by dragging the slider (for Insteon dimmers) to adjust the dim level. Note: The command to dim the Insteon module is only sent out when you release your finger from the slider.
For Insteon toggle switches, iLinc gives you a On/Off switch that you can touch to turn the Insteon device on or off. This will also show the current state of the Insteon Module.
The current state of X10 is a little different. Currently iLinc only supports sending X10 commands. Only some X10 modules will report their status when asked. iLinc currently does not support retrieving status for these X10 modules.