I just purchased MobiLinc HD for my iPad and iPod Touch. The program works fine on my iPad, but there are problems with it on my iPod Touch. When I attempt to make any changes (i.e., manually add a device or change to a Module Friendly Name, etc) I get a error message that says "Invalid X10 Address. The X10 address entered is invalid. Use the format [A-P][1-16]".
My devices are NOT X10 devices, but Insteon modules. In fact, I identify them as "SwitchLinc Dimmer" on the Add Device/setup page, but it still gives me the "Invalid X10 Address" message. Yes, I am entering the valid Insteon ID in the correct format. The funny thing is this even happens when I try to change the "Module Friendly Name" of one of the SwitchLinc Dimmers that is showing up in MobiLinc. Of course, it is worse when trying to manually add a device because with the error, it won't even allow me to add a valid device. At least with the modules that were recognized through syncing it shows the devices but they are only identified by Insteon ID which is very confusing.